Forum Discussion
Lynxus_177337
Nimbostratus
NimbostratusWhy doesnt Vlan and IP information "sync" ?
Hi Guys,
I am fairly new to this, I have two F5 LTM's with a dedicated HA cable/vlan between them.
HA is created, both are talking active/standby however, if i create a Layer2 vlan on the a...
Actually LTM sync is little bit differ than other devices, the network part which include ip addresses, vlans, trunks, route,.... is not included in sync process. so you have to do it manually in both units, make sure you are using same name in each node, both should be identical
Mahmoud_Eldeeb_
Cirrostratus
CirrostratusActually LTM sync is little bit differ than other devices, the network part which include ip addresses, vlans, trunks, route,.... is not included in sync process. so you have to do it manually in both units, make sure you are using same name in each node, both should be identical
Lynxus_177337Ah ok, So I guess "load balance stuff" , Nodes, Vips , Persistence etc etc will sync. But network ( underlying stuff ) must be manual? Sorta makes sense I guess.- Mahmoud_Eldeeb_not only load balance staff, everything is synced except network part