Forum Discussion
CirrusUser access to servers
Very well ,
Change " service port 0 " to your needed port "7134"
This mandatory in your Case.
> Virtual server "100.68.0.8" listens on 443 , it performs destination NAT to both Pool_members "100.66.0.8" and "100.66.0.7".
But What about the port translation ,
443 port can not be translated to port "0" , Port "0" means any.
so in this case , F5 does not perform a Port address translation it transfer the traffic on Port 443 as it is without translation to port 7134.
> so the needed action is to change "0" to 7134 on both of pool members.
Thats why you access it when configuring the virtual server to listen on port 7134 not 443 as you did recently.
try it and tell me.
it will work isa.
Well , could you please figure out your scenario.
Also , do you want web1 and web2 in the same pool or separate pool , I mean do you make f5 loadbalance between them by using single virtual server or 2 virtual servers , one for 8080 service and the other for 8090.
Please send more clarification
Cirruseach server has it's own virtual server and each one of the web1 and web2 are in separate pool
Well ,
Have you created a dns A record to points to each virtual server ip on f5.
I mean
Web1.abc.com = virtual server ip
> Also , have you created a client ssl profile contains " ssl wildcard certificate and key " and attached it to your Virtual server , I expect that the wildcard certificate like "*.abc.com".
> Also make sure you make the virtual servers listen to port 443.
> make sure that you configure SNAT " Auto map " or "SNAT pool"
If the gateway of your servers isn't F5 , so configure source nat.
Make sure for all of the above and send the feedback.
- MustphaBassim
hello dear
yah i did the above steps but still not working , when i put the server on 443 it's not response and when back to orignal port it is working fine
Hi MustphaBassim ,
Make sure that the Configuration on your Virtual server Like these snap shots :> in last snapshot : Address translation and Port Translation , both should be enabled.
you find it when clicking advanced not Basic under configuration section.
See it and send your Feedback.
or send a snap shot from your Configuration if this available with you.
