Forum Discussion
NimbostratusUnable to access vCMP guests on one slot
Hello
I have a Viprion with 2 blades PB300 in slot 2 and 3. These 2 blades comes from another viprion. I just activate the vCMP license and merge a config file with the new vlans and interfaces. Loading configuration without error.
The two blades have their management port connected.
When i create a guest on blade 2 i can't access it. If i create the same guest on blade 3 the access is possible.
It's not a problem of network access (crossing management cable give the same result)
The address for the guests are in the same vlan than the host and the 2 blades management address. The blade on slot 2 is accessible by her management address.
Any idea ?
Thank you
Frédéric
2 Replies
Do the guests on that blade have their Management Network setting set to Bridged or Isolated?
Can you use the vconsole tool to connect to the CLI of those affected guests?
Have you tried relocating the blade to a different slot?
It should not matter, but do you have cluster IPs assigned to each blade?
fraguet_53463"Do the guests on that blade have their Management Network setting set to Bridged or Isolated?" it's bridged
"Can you use the vconsole tool to connect to the CLI of those affected guests?" Yes, i can connect with the vconsole tool. But the guests are "INOPERATIVE".
"Have you tried relocating the blade to a different slot?" Yes
"It should not matter, but do you have cluster IPs assigned to each blade?" Yes.
News are better this morning. I can create and access guest. But my ancient guest are not accessible. I will erase them and re-create.
Thanks for your help.
