Forum Discussion
starboy
Cirrus
CirrusTelnet VIP
Hi All I have 2 servers(nodes) in the same pool and Virtual server and i want to telnet to this VIP so how can i telnet the virtual server both in http and https assume the virtual server ip is 192.168.100.1 and i type in cmd telnet 192.168.100.1 443 telnet 192.168.100.1 80
Martijn_144688Cirrostratus
Hi,
I am not sure what your question is, but if you want a virtual server on port 80 and port 443, you need to create two vitual servers on the same IP. One VS for HTTP and one VS for HTTPS.
Off course you can create a virtual server on any port, but maybe this is not what you want.
Regards,
Martijn.
- MvdG
Hi,
I am not sure what your question is, but if you want a virtual server on port 80 and port 443, you need to create two vitual servers on the same IP. One VS for HTTP and one VS for HTTPS.
Off course you can create a virtual server on any port, but maybe this is not what you want.
Regards,
Martijn.
Only1masterbla1Telnet should work for Port 80 but it will not work for SSL ports. Note that backend pool member will not respond unless it receives some data request (e.g. GET/POST etc). You should use curl type of utility to test connectivity.
