Forum Discussion
consul_2019
Cirrus
What happens when you force your active unit to standby; Does the peer start sending logs?
Gajji
Mar 06, 2020Cirrostratus
1)No.. what i found is route to syslog goes via vlan_external from primary
but on seconday device its goes via eth0 interface
2)when i tried to change the route on secondary through GUI and sync from primary ... Secondary device route will be gone
3)Also when i run on secondary cli.. netstat -rn
i see the specific route to syslog ... how do i remove it , this route cant be seen on Gui