Forum Discussion
SSHSSH_97332
Nimbostratus
NimbostratusSpecifying unicast addresses for failover
When specifying unicast, rather than multicast, addresses for failover, you
need to specify two pairs of IP addresses, where one of the pairs indicates
the management IP addresses of the tw...
nitass
Employee
Employeemgmt interface/ip is always available while tmm interface/selfip is not. for instance, while booting bigip, tmm might not be ready fast enough and ha pair might end up with active-active if only selfip is configured in unicast pair since unit is not able to reach peer's selfip.