Forum Discussion
CirrostratusSNMP walk is not workin after update to 15.1.2
Cirrostratusyes i restarted snmpd service...still not working i tried same command in version 14 and version 15.1.0 its works fine.. only on version 15.1.1 and 15.1.2 is not working.
NacreousCan you give me you snmpwalk command for syntax check ?
- F5_LB_Eng
snmpwalk 2.9.22.1 -v2c -c SNMPCOMLAB system
- Lidev
if you run this command below on your F5 BIG-IP, it's work's ?
snmpwalk -v2c -c SNMPCOMLAB localhost system - F5_LB_Eng
yes it works
local host work ..but remote host is not working...i added the remote host in the allowed list
- F5_LB_Eng
snmpwalk -v-c SNMPCOMLAB 25.96.225.4 bigipSystem
Timeout: No Response from 2.9.5.4
- Lidev
if you try to test a snmpwalk on remote host, you need to add IP Address of the host :
snmpwalk -v2c -c SNMPCOMLAB x.x.x.x MIB - F5_LB_Eng
not working...
- F5_LB_Eng
Timeout: No Response from 25.96.225.4
- F5_LB_Eng
the command works fine with version 14.1.2.3 and 15.1.0.3 but its not working with 15.1.1 and 15.1.2
- Lidev
Check that the IP Address configure in allowed-list on host 25.96.225.4 is actually the management address of your F5 BIP-IP from which you send your snmpwalk.
tmsh list sys snmp allowed-addresses - Lidev
if the allowed-list is well configure, send ticket to support F5 maybe you're facing with a bug on 15.1.2.
