Forum Discussion

Cirrostratus

Nov 26, 2020

SNMP walk is not workin after update to 15.1.2

Hi, i have upgraded to 15.1.2 . after upgrade snmpwalk is not working from standby to active device. its work fine with version 14.1.x . while testing i have added allowed list IP ...

Cirrostratus

Nov 27, 2020

yes i restarted snmpd service...still not working i tried same command in version 14 and version 15.1.0 its works fine.. only on version 15.1.1 and 15.1.2 is not working.

Lidev
Nacreous
Nov 27, 2020
Can you give me you snmpwalk command for syntax check ?
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  
  snmpwalk 2.9.22.1 -v2c -c SNMPCOMLAB system
- Lidev
  Nacreous
  Nov 27, 2020
  if you run this command below on your F5 BIG-IP, it's work's ?
  snmpwalk -v2c -c SNMPCOMLAB localhost system
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  yes it works
  
  local host work ..but remote host is not working...i added the remote host in the allowed list
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  snmpwalk -v-c SNMPCOMLAB 25.96.225.4 bigipSystem
  Timeout: No Response from 2.9.5.4
- Lidev
  Nacreous
  Nov 27, 2020
  if you try to test a snmpwalk on remote host, you need to add IP Address of the host :
  snmpwalk -v2c -c SNMPCOMLAB x.x.x.x MIB
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  not working...
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  Timeout: No Response from 25.96.225.4
- F5_LB_Eng
  Cirrostratus
  Nov 27, 2020
  the command works fine with version 14.1.2.3 and 15.1.0.3 but its not working with 15.1.1 and 15.1.2
- Lidev
  Nacreous
  Nov 27, 2020
  Check that the IP Address configure in allowed-list on host 25.96.225.4 is actually the management address of your F5 BIP-IP from which you send your snmpwalk.
  tmsh list sys snmp allowed-addresses
- Lidev
  Nacreous
  Nov 27, 2020
  if the allowed-list is well configure, send ticket to support F5 maybe you're facing with a bug on 15.1.2.