Forum Discussion
Hi Eric,
Thanks for your reply.. here are my updates,
1.) Are you attempting to perform SNMP polling on the management IP, or a Self IP? If it is a Self IP, what is the Port Lockdown setting on that Self IP?
To perform on Management IP and self-IP to send SNMP data to the SNMP server.
After I select the Port Lockdown setting on the self-IP as below. the settings unable to update
.
2.) What are you expecting to see on the SNMP server? i can see the snmp show F5 device properties only. the SNMP server should be able to see the CPU performance, disk/memory utilization , device down (alert) for e.g.
3.) Are you performing SNMP polling, or are you expecting traps?
SNMP polling and traps as well.
4.) If you are expecting traps, is there a route on the BIG-IP to the SNMP server?
able to ping to the destination SNMP server
5.) Is port 162 opened on any firewalls along the path?
Ports opened.
- Eric_St__JohnMay 20, 2015EmployeeIf you're seeing device properties then you are successfully reaching the device via SNMP. What SNMP server software are you using?