Forum Discussion
Kim_Kipp_49723
Nimbostratus
NimbostratusSNAT by Destination IP
I want to mask a network behind an SNAT IP address based on the following criteria: either the leaving interface (WAN) or the desitination IP. Is there a way to solve that by configuration utility? O...
Kim_Kipp_49723Nimbostratus
NimbostratusI already have a wildcard virtual server connected to all interfaces. So I can append the iRule to that virtual server. Well I'm not that familar with iRule, just at the beginning. So it would be very helpful if you can post some syntax.
Network 192.168.10.16/28 should be natted to x.x.x.x if it is going out on interface "TestWAN". If it is going out on interface TestLAN it should not be natted. The network 192.168.10/16 is not a direct attached network to F5!
What_Lies_Bene1
Cirrostratus
CirrostratusJust putting something together now. As I said it can't be done based on egress interface, only destination IP/subnet. Is there more than one?
