Forum Discussion
usmansa1
Altostratus
AltostratusSite stuck during provisioning ?
Hi All,
yesterday I installed the site with secure mesh and after some time the site got stuck in provisioning state, when I run some commands to see the status of the site and it shows below mentioned output
"status ver" : "The service is being restarted"
"config-network" : "The site is in provisioning state"
Moreover the ssh and https access to the site was also lost and "health" command is also not showing any IP address configured, rebooted the site and nothing works. When checked the main console it shows like the site is being upgraded. Waited for 2 to 3 hours no difference. Also checked the F5 Zendesk document but couldn't able to relate to my situation. Left the site overnight and in the morning just rebooted the site and it actually provisioned. I observed the similar behavior during the F5 lab when the site was upgraded. it took atleast 6 to 7 hours of to upgrade and then the after the manual reboot the site got working. I just wana know is it a default behavior or am I missed something ?
- Nikoolayy1
MVP
For me it is not . You can check the VPM logs as this are the most important logs during CE registration/provisioning and upgrade Troubleshooting Manual Site Deployment Registration Issues | F5 Distributed Cloud Tech Docs
usmansa1Hey mate nothing was working at that time when it was stuck i had to manually reboot the site from VMWare like power off and power on
- Nikoolayy1
There is new article Troubleshooting Guidelines for Customer Edge Site | F5 Distributed Cloud Tech Docs that shows some cool troubleshooting tips for XC Customer Edge CE.
