Forum Discussion
artl2377_166103
Nimbostratus
NimbostratusSeemingly high memory ussage
I have a newly installed 2000s . It is configured but doing squat while customer gets his routing sorted out. It has only 10 VIPs and 15 nodes. The cpu is reporting 15% and highest used mem is 45% [TMM other] Both of these seem high for a machine that is at rest. Come Jan testing will ramp up to potentially a lot of users [ie in the 000]
Is the memusage high or is that what you would expect to see ?
The other problem is the GUI ... clicking the Virtual servers tab - takes 3 minutes to load :( . The rest of the tabs seem a tad sluggish - but 3 mins to load the VS is :(
Thanks in advance
Wonder why the VS tab takes so long to load
is Display Host Names When Possible (under System > Preferences) enabled?
nitassEmployee
highest used mem is 45% [TMM other]
what is tmm other? is it other memory used? how much is tmm memory used?
this is output from my idle virtual edition.
root@(ve11a)(cfg-sync In Sync)(Active)(/Common)(tmos) show sys performance system raw Sys::Performance System (raw) ------------------------------------------------------------------- System CPU Usage(%) Current Average Max(since 12/21/14 14:28:32) ------------------------------------------------------------------- Utilization 3 3 33 ------------------------------------------------------------------- Memory Used(%) Current Average Max(since 12/21/14 14:28:32) ------------------------------------------------------------------- TMM Memory Used 10 10 10 Other Memory Used 62 61 62 Swap Used 17 17 17The cpu is reporting 15%
i think it is normal.
artl2377_166103Cheers thanks. The only other LTM i have access to is a Viprion which never raises a sweat - the stats from that are pretty meaning less.
Wonder why the VS tab takes so long to load ... thought it may have been the memory but looks not be the case :(
thanks again
nitass_89166Noctilucent
Wonder why the VS tab takes so long to load
is Display Host Names When Possible (under System > Preferences) enabled?
- artl2377_166103You lill beauty you !! on the mark - yes it was enabled - disabled it an now all good and perky again. :) Thanks very much
Jay42Had the same problem, DNS servers were not reachable. But I like this solution better.
- nitass
Wonder why the VS tab takes so long to load
is Display Host Names When Possible (under System > Preferences) enabled?
- artl2377_166103You lill beauty you !! on the mark - yes it was enabled - disabled it an now all good and perky again. :) Thanks very much
- Jay42
Had the same problem, DNS servers were not reachable. But I like this solution better.
- artl2377_166103
You lill beauty you !! on the mark - yes it was enabled - disabled it an now all good and perky again. :)
Thanks very much