Forum Discussion
NimbostratusRouting Between DMZ & LAN using F5
Hello Everybody,
I'm new on the F5 world, and I have a question about a configuration that I'll want to simulate using F5.
This is related to Vmware View architecture, that's the security server must reside on the DMZ network.
But all the rest of the servers reside on the LAN network.
So for that I want to use F5 with its functions, plus routing the traffic between the two networks.
I hope that I give an approach scenario of my issue.
Thanks in advance
45 Replies
nitass_89166Noctilucent
So what will be the solution at your opinion please.
have you tried to ping server ip (not self ip)? pinging server ip should work.
Jimb2k_159873No, It's not working too- nitass_89166have you checked tcpdump?
- Jimb2k_159873I Have already paste the result of the tcpdump
- nitass
Employee
So what will be the solution at your opinion please.
have you tried to ping server ip (not self ip)? pinging server ip should work.
- Jimb2k_159873No, It's not working too
- nitasshave you checked tcpdump?
- Jimb2k_159873I Have already paste the result of the tcpdump
- Jimb2k_159873
Hello Guys,
Thank you for your support.
Finally, This is working for me.
It's related to the Vswitch that I assigned to the Nic cards.
After Do this, the configuration was right and the ping between the host working as charm.
Thank you very much again and again.
