Forum Discussion
karthic_n_12765
Nimbostratus
NimbostratusRedundant pair management
Hello,
From the iControl SDK, I am unable to figure out which iControl methods I need to call to get the following simple pieces of information related to redudant pair configuration:
1....
karthic_n_12765Nimbostratus
NimbostratusJoe,
About 2, I want to know whether the mode of operation is active-standby OR active-active and NOT whether a device is in active or standby state. I think your reply addresses the latter issue.
About 4, by preferred active unit, I mean the option in BIG-IP where you can designate one of the units in the redundant pair to have preferrence over the other when both units are eligible to be active. Section 5 of the "BIG-IP reference guide" talks about this feature.
Thanks,
Karthic.
