Forum Discussion
Asura2006
Altocumulus
AltocumulusPriority group activation and automatically closing connections when higher priorty group goes UP.
Hello we have a configuration where in one pool there are 6 nodes with 2 priority groups of 3 nodes each. 3 nodes with piriority group 1 (backup) 3 nodes with priority group 10 (primary). Priority...
Hi Asura2006 ,
The default behavior of Priority group Activation is when the Backup PG activated it handles your connections , but when higher PG is returned UP and active again , all comming new connections is handled by "main" PGA and the Backup PG handles only Active connections till it completes.
I see this is a good behavior to be done by PGAs and this is the default.
If you see that the new connections don’t be handled by "main" PG when it became actve , check if you enable " manual resume " option under assigned monitor configuration.
> Do you want to transfer active connections to be handled by "main"PG when it became available again ?
specify more please in this section.
Regards
Asura2006 ,
Do you configure any type of persistence profiles ?
the default behavior , your new connections should be handled by "main "PGA when it becomes available, only Active connections should be handled by the "Back up" PGA till complete.