Performance decrease using a S-NAT Pool

Hello,

Thank you for your answer. I have now only one SAP-router in the pools active and the same behavior. I takes round 10 Seconds to connect. I have actually no float-ip setup. From advanced bash I can connect in time when I use the Interface IP of the LTM as in your exapmple. As soon as I use one of the IP's defined in the SNAT pool I get

nc -v -s 10.24.101.8 -w 3 10.24.100.69 3299 nc: bind failed: Cannot assign requested address

OK you are right there is not really a need for such a big range... but I expected that it is not important if take 3 or 25 ...

Regards Gerhard