Forum Discussion
Abed_AL-R
Cirrostratus
Cirrostratusowa iapp assign irule
Hi How to assign an iRule to a virtual server in iApp template I created iapp for owa 2010 using: f5.microsoft_exchange_2010_2013_cas.v1.6.2 , with APM authentication before but the logout funct...
Hello,
The Strict Updates option is enabled by default on deployed iApp template. This is for protection against any kind of accidental changes to an iApp. If you want to make any changes to it e.g. adding iRule in your case, you need to disable Strict Updates and then make changes. DO NOT FORGET to Re-enable the Strict Updates again post adding iRule.
NOTE - It is recommended to keep the Strict Updates setting enabled and make any changes to the iApp's configuration by modifying the template. But if its not possible to modify it directly, you can disable settings for time being. This shouldn't cause any negative impact on the traffic.
Strict Updates setting is available under --> iApps -->Application Services -->Properties-->Advanced
Hope it helps!
Mayur_Sutare
MVP
MVPHello,
The Strict Updates option is enabled by default on deployed iApp template. This is for protection against any kind of accidental changes to an iApp. If you want to make any changes to it e.g. adding iRule in your case, you need to disable Strict Updates and then make changes. DO NOT FORGET to Re-enable the Strict Updates again post adding iRule.
NOTE - It is recommended to keep the Strict Updates setting enabled and make any changes to the iApp's configuration by modifying the template. But if its not possible to modify it directly, you can disable settings for time being. This shouldn't cause any negative impact on the traffic.
Strict Updates setting is available under --> iApps -->Application Services -->Properties-->Advanced
Hope it helps!