Forum Discussion

Raja_Tomar_7476's avatar
Raja_Tomar_7476
Icon for Nimbostratus rankNimbostratus
Aug 03, 2005

node <ip addr>[:<service>] ... enable Not working

Hi,

I am using following commands of bigpipe to enabling/disabling nodes. 


node [:] ... enable
node [:] ... disable

These commands are working along with service e.g. 


bigpipe node 204.10.122.11:80 disable

Is working fine but when I tried to enable/disable perticular node (for all services) kind of ADDR DISABLE. I tried the following


bigpipe node 204.10.122.11 disable

But it is not working. Is it the correct way to do this? If not then can you please tell me that how can I ADDR DISABLE any node.
dev
devops
iControl
v4
  • Joe_Pruitt's avatar
    Joe_Pruitt
    Aug 08, 2005
    Just a disclaimer, this is really a product related question and with such you should be going through F5 Product Technical Support. The iControl forums are for assisting in the development of applications utilizing our iControl APIs.

     

     

    But, you could phrase this question differently by not using the bigpipe commands but the iControl equivalents. I'll assume that you did so this time...

     

     

    What exactly isn't working? When you disable a node address, is it's status still showing up as enabled? Or is it disabled when you view the node status but enabled as a pool member? Just saying that it isn't working doesn't really give us much to go by.

     

     

    -Joe