Forum Discussion
Nimbostratusmilli-voltage (<voltage>) is too low ,Power supply failure </voltage>
Hi, I am getting the following message on the display.
milli-voltage () is too low ,Power supply failure
But I can see the following outputs Chassis Power Supply Status Index Status Current 1 up AC 2 up AC
Chassis Fan Status Index Status Low Limit(rpm) Fan Speed(rpm) 1 up 1000 12200 2 up 1000 12000 3 up 1000 12200 4 up 1000 12000
Accroiding to F5 document,it says Description:This message occurs when one of the following conditions is met: External power to the PSU is lost. Input power readings are out of the recommended range.
What is the solution?Any clue?? Thank You
RaghavendraSY_7Cumulonimbus
Please refer and check whether your device model is mentioned in below article.
https://support.f5.com/csp/article/K17356
sena_291474Thanks a lot for the quick response.But unfortunately,my device not in the listed category.
RaghavendraSYAltostratus
Please refer and check whether your device model is mentioned in below article.
https://support.f5.com/csp/article/K17356
- sena_291474
Thanks a lot for the quick response.But unfortunately,my device not in the listed category.
- RaghavendraSY
You can verify the below article.
https://support.f5.com/csp/article/K38417018
Suggest you to open a ticket with the f5 vendor.
- sena_291474
I have already opened a case with F5.
- RaghavendraSY_7
You can verify the below article.
https://support.f5.com/csp/article/K38417018
Suggest you to open a ticket with the f5 vendor.
- sena_291474
I have already opened a case with F5.