Matching Source and Destination for NAT

You can set up a selective SNAT instead of using an iRule.

 

 

Enable SNAT AutoMap on at least one floating self-IP address on the egress VLAN.

 

 

Then create a new SNAT, with the following settings:

 

-Translation: Automap

 

-Origin: Address List

 

--Type: Network

 

--Address: 10.100.104.0

 

--Mask: 255.255.255.0

 

-Enabled on: At least the egress VLAN

 

 

And finally, if the traffic will traverse a pool, ensure that "Allow SNAT" is still enabled on that pool. (Enabled by default)

 

 

That will translate all connections originating from the address list to the automap address, and all other connections will go un-SNAT'd.

 

 

/deb