Cirrusi looked around in KB articles and got the answers to all 3 question - so all good
MVPHi, F5 uses only ip addresses configured under failover config for exchanging the heart beats & checking the health of the peer device.
Cirrusthanks for the reply
the problem i am facing that - heartbeats are dropping and both devices are constantly becoming active - i dont see any issue on the hypervisor side (network interface).
question -
1 - how many heartbeats need to fail for the device to become active ?
2 - can i tweak those settings ?
3 - if i add a third network - would both of them have to fail for device to become active ?
thanks
Cirrusi looked around in KB articles and got the answers to all 3 question - so all good