Forum Discussion
Justin_18188
Nimbostratus
NimbostratusiRule variable problems
I have an iRule that captures the SSL client DN and places it in a variable to be passed to an application. 98% of the time, there is no problem. But 2% of the time, user's CN get crossed. One person ...
Justin_18188Nimbostratus
NimbostratusNo, we are using a TCP profile with a few settings changed. I'll put it all out there though:
Reset on Timeout - enabled
Time Wait Recycle - enabled
Delayed ACKs - enabled
Proxy Maximum Segment - not checked
Proxy Options - not checked
Proxy Buffer Low - 98304 bytes
Proxy Buffer High - 131072 bytes
Idle Timeout - 300 seconds
Time Wait - 120000 seconds
Fin Wait - 5 seconds
Close Wait - 5 seconds
Send Buffer - 65535 bytes
Recieve Window - 65535 bytes
Keep Alive Intreval - 1800 seconds
Max Syn Retransmissions - 3
Max Segment Retransmissions - 8
IP ToS - 0
Link QoS - 0
Selective ACKs - Enabled
Extended Congestion Notification - not checked
Extensions for High Performance - enabled
Limited Transmit Recovery - enabled
Slow Start - not checked
Deferred Accept - not checked
Bandwidth Delay - not checked
Nagle's Algorithm - not checked
Acknowledge on Push - enabled
MD5 Signature - not checked
MD5 passphrase -
Congestion Control - New Reno
Congestion Metrics Cache - enabled
Appropriate Byte Counting - enabled
D-SACK - not checked
This is in use with a BEA application and was configured by some people that never worked with anything F5 before.
