Forum Discussion
Sebastien_Paque
Nimbostratus
NimbostratusHelp configuring NAT64 on a BIG-IP LTM
Hi everyone,
I have been trying to implement NAT64 in our network in order for IPv6 only clients can reach our IPv4 only servers.
Being relatively new to the product, I have had a bit of difficu...
You may need to run packet captures at this point to determine why the page isn't loading:
tcpdump -nni 0.0:n -s0 host 2001:b3e:45f1:6121::7 (client side)
tcpdump -nni 0.0:n -s0 host 192.168.1.7 (server side)
You can have pool members or virtual servers specifying all ports, but your pool member can't be monitored on all ports. The monitor must be specific to a certain protocol/port. If this is an HTTP connection only, then it's best to have your pool member configured with port 80.
Sebastien_PaqueNimbostratus
NimbostratusNever mind my last comment, it was able to do the trick! I had an iRule I forgot to remove on the VS. I am reaching the server no problem now.
Do you know how different it would be to create actual NAT64 instead of only balancing it ?
Thank you so much for your help!
Cory_50405Noctilucent
I've not used NAT64. I think it's mainly for CGNAT scenarios which we aren't licensed for: http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/cgn-implementations-11-3-0/2.html Glad to hear your setup is working now.