Force a BIG-IP LTM Offline

I am preparing for life cycle replacement of the F5 hardware. This will replace 6400's with Viprion guests. The question is using the "Force Offline" as a quick way to transition to a new HA pair.

 

 

Does this keep it from assuming the floating IP? Perhaps it drops all of its self IPs?

 

I can assign new self IP's to the new HA pair, but I want the new one to be using the same floating IP as the old ones.

 

 

Process would be for prep:

 

1.'force offline' on the old standby member of the HA pair so it won't become active.

 

2. on the new HA pair do 'force offline' on both units, then bring them onto the network. They won't assume the VIP or anything, but the resources behind it (nodes, pools, etc) should come alive and we can verify that all is well and ready.

 

 

Changeover:

 

1. 'force standby' on the old, active unit. this will free up the float.

 

2. on one new unit, 'Release Offline' to bring it active. It will grat. ARP and the virtual servers will become active.

 

3. 'release offline' on the second HA member, probably after verification of applications have been completed.

 

 

Falllback:

 

reverse this and force the new units offline, bring at least one of the old units back online.

 

 

My other option was to work on the switchports and bring the interfaces down on the old boxes (easiest).

 

On the new place the VLANs into the guest to bring them active.

 

The problem with this is that I can't verify that the resource nodes and pools are all good before flipping the switch.

 

 

Comments, suggestions, recommendations for a clean cut over? Thanks!!!!