Forum Discussion
mrp_235984
Nimbostratus
NimbostratusF5 Reboot
I am supposed to reboot a load balancer pair using "full_box_reboot". I was gonna reboot the standby box first and then interchange Active Standby boxes to reboot the active box (which is now standby...
Yann_Desmarest_
Nacreous
NacreousHi,
Using the webui, you can force the active unit to standby by following the below procedure :
- Go to the webui of the active unit
- Go to Device Management >> Devices
- Select your actual active unit
- press "Force to standby" button
- press "OK" when the webui prompt you for a popup asking : "Force this device to standby ?"
Your active unit should switch to standby. Pay attention that the "auto fallback" is disabled in the device group. Otherwise, the newly standby unit will come back to active state.
mrp_235984Nimbostratus
NimbostratusDo you have any additional tips or advice?
