Forum Discussion
genseek_32178
Nimbostratus
NimbostratusF5 config sync issue
2 BIPGIP pairs are setiup in Active and Standby State, Config Sync status is - o, Synchronized on both devices, but configs r not same.
Virtuals in Active are not getting Sync to Standby.
When searching missing virutals on Standby, message coming is - Virtual not found.
Does it mean, virtuals need to be configured on Standby and then configured synched manually?
12 Replies
genseek_32178In the below, pool config, monitor is applied for HTTP port monitoring, but the nodes are associated with SNMP service. This is not correct, i guess, right?
b pool pool_http list
pool pool_http {
monitor all http_p
members {
172.20.20.25:snmp {}
172.20.25.30:snmp {
IT SHOULD BE, as below. Please confirm.
b pool pool_http list
pool pool_http {
monitor all http_p
members {
172.20.20.25:http {}
172.20.25.30:http {- nitass
Employee
In the below, pool config, monitor is applied for HTTP port monitoring, but the nodes are associated with SNMP service. This is not correct, i guess, right? not really. there is a case which you may want to mark pool member down if another service (e.g. http) on the pool member is down. there are alias address and alias service port settings which will show when selecting configuration advanced in health monitor setting screen.
