Forum Discussion
Gerald_Meese
Cirrus
CirrusCopy over self IPs from several partitions
Hello, I'm preparing the migration of an active/standby cluster of 2 LTM devices to new virtual devices. Per F5 support case I cannot use an UCS migration due to different trunk settings on both si...
I wonder if this is as simple as not setting a default route domain for your other partitions? Try to set that before the import, rather than modifying the IPs to put the route domain in with the %xxx syntax. You have to first define the route domain object (net route-domain), then set the partition to it.
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# create net route-domain rd_foo id 1234 vlans replace-all-with { con1 }
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# list auth partition foo all-properties
auth partition foo {
default-route-domain 0
description none
}
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# modify auth partition foo default-route-domain 1234
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# list auth partition foo all-properties
auth partition foo {
default-route-domain 1234
description none
}
Lucas_Thompson
Employee
EmployeeI wonder if this is as simple as not setting a default route domain for your other partitions? Try to set that before the import, rather than modifying the IPs to put the route domain in with the %xxx syntax. You have to first define the route domain object (net route-domain), then set the partition to it.
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# create net route-domain rd_foo id 1234 vlans replace-all-with { con1 }
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# list auth partition foo all-properties
auth partition foo {
default-route-domain 0
description none
}
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# modify auth partition foo default-route-domain 1234
admin@(west)(cfg-sync Standalone)(ModuleNotLicensed::Active)(/Common)(tmos)# list auth partition foo all-properties
auth partition foo {
default-route-domain 1234
description none
}
Gerald_MeeseCirrus
CirrusI found the issue 🙂 when I use a concatenated command to move to Partition1 and run the import, it fails (silently) and stays in partition /Common :
tmsh -c "cd /Partition1; load /sys config merge file Partition1-selfip.txt verify"
When I do the same using 2 commands in sequence... it works like a charm 🙂
Thanks for your help!!
Gerald