Forum Discussion

SSHSSH_97332's avatar
SSHSSH_97332
Icon for Nimbostratus rankNimbostratus
Jan 05, 2012

Control Time of Failover

if standby unit failed to detect active unit for X seconds on Newtork cable on HA vlan , Fail-over will happen

What is default for this X & how to change it ?

 

also what is the same fro Hardware failover ?

 

 

 

config
design
  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Jan 05, 2012
    What is default for this X & how to change it ?i understand it is Failover.NetTimeoutSec db variable which is 3 seconds by default.

     

     

    sol2397: Comparison of serial failover and network failover features

     

    http://support.f5.com/kb/en-us/solutions/public/2000/300/sol2397.html

     

     

    also what is the same fro Hardware failover ?i do not think so. please review sol2397 above.
  • SSHSSH_97332's avatar
    SSHSSH_97332
    Icon for Nimbostratus rankNimbostratus
    Jan 05, 2012
    Thx , the link mentioned default for Network failover , it didnot mentioned abou default value for serial failover

     

    Also how can i cahnge these values from GUI ( or CI if GUI is not possible )

     

  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Jan 05, 2012
    how can i cahnge these values from GUI ( or CI if GUI is not possible ) i do not think it is configurable.