Forum Discussion
Greg_Black
Altostratus
AltostratusConfiguring the management IP for a new VE BigIP LTM
Hey guys,
I am putting in place a new VE BigIP LTM version 11.4.1 to take the place of an older 10.2.2 VE. The older one is still up and running so I am not currently using that mgmt IP. The new VE is a VHD and has been setup using settings that match the older one, (VLAN, RAM, CPU, etc).
-On the new VE, I have manually removed DHCP: tmsh modify sys global-settings mgmt-dhcp disabled
-Next, I added a new IP for the management IP: tmsh create /sys management-ip
/
-Once I added it, I verified it by using this: tmsh list /sys management-ip
All appears to look good, but for some reason it will still not allow me access to the GUI. Am I missing something here? Any help or direction would be greatly appreciated.
GB
IainThomson85_1Cumulonimbus
Have you removed the MGMT IP from the old device ?
Greg_BlackNo, because it is still in use. I have put a different Mgmt IP in place for the new F5 so that I can configure it in the GUI.
boneyardMVP
route perhaps?
is there a reason why you don't use the usual command: config ?
NUT2889Cirrostratus
Did you run "tmsh save sys config"?
Motsware_231000Nimbostratus
I had the same issue only to find out that the firewall was blocking the traffic. Enabled https traffic to the management ip address of the F5 to resolve the issue.