Forum Discussion

Agathe_309970's avatar
Agathe_309970
Icon for Altocumulus rankAltocumulus
Aug 03, 2017

Change the timeout according a pool member

Hi,   I want to change the timeout for one pool. But it depends of a TCP profile (which is apply to a virtual server). Is there a solution for change this timeout without affect the other pool mem...
application delivery
BIG-IP
LTM
  • Martijn_144688's avatar
    Martijn_144688
    Aug 04, 2017

    Hi,

    You can try to test with the iRule below.

    when SERVER_CONNECTED {
   if { [IP::addr [LB::server addr] equals 10.10.10.10] } {
       set TCP::idletime 10
  } else {
        set TCP::idletime 300
  }
}

    Where 10.10.10.10 is the IP-address of the pool member.

    Good luck.

    Martijn.

MvdG's avatar
MvdG
Icon for Cirrus rankCirrus
Aug 04, 2017

Hi,

You can try to test with the iRule below.

when SERVER_CONNECTED {
   if { [IP::addr [LB::server addr] equals 10.10.10.10] } {
       set TCP::idletime 10
  } else {
        set TCP::idletime 300
  }
}

Where 10.10.10.10 is the IP-address of the pool member.

Good luck.

Martijn.

  • Agathe_309970's avatar
    Agathe_309970
    Icon for Altocumulus rankAltocumulus
    Aug 04, 2017

    Hi,

    Thank for your response. Yes I just found some response with the iRule. I tested this iRule which seems working.

    when HTTP_REQUEST {
    if { ([HTTP::host] == "abc.com") } {
        IP::idle_timeout 1800
        set serverside_idle_timeout 1
    }
}
when SERVER_CONNECTED {
    if {$serverside_idle_timeout} {
        IP::idle_timeout 1800
    }
}

    Thanks a lot for your help.

    Agathe