Forum Discussion
mportnoy
Nov 29, 2023Nimbostratus
This works great to connect to active Big-IP via APM VPN. Thank You!
I have an HA pair of Big-IPs. Loopback (127.0.0.1) IP always redirects to active Big-IP, even if I have primary & standby inside Big-IP IPs. Is it possible to configure access to both active and standby units?
I could create 3 sets of VIPs with it's own iRule for each, with inside VLAN IP instead of loopback address.
1 set for HA Unit 1 inside IP
1 set for HA Unit 2 inside IP
1 set for shared inside IP
Instead, is it possible to make the iRule intelligent enough to determine requested destination IP, and send to that desination IP.