Forum Discussion
Christopher_Noy
Nimbostratus
NimbostratusCannot add device to Peer List
Hello,
After seeing some peer device weirdness after upgarding my active and standby 4200v's to 11.6, I wiped the HA config and started over. I am at the stage to add a device to the peer device l...
Is the device reachable? (ping)
Did you create a separate HA_vlan (self IP) for failover/config sync? (if so, try to use this IP to add the peer device), assuming it is also reachable.
Christopher_NoyYes, it is reachable (both devices can ping each other's mgmt IP). There is already an HA_vlan created (with "self IP" addresses assigned). Those are also pingable from each device at the CLI. I've tried using the self IP's as well. Still no joy. Up until I removed the devices in the peer group, this was working. Not sure why I can't add them back in now.- NTP configured? Reset the device trust (generate a new self signed cert)
- Christopher_NoyNTP is configured (and has been). I also reset the device trust (and generated a new cert) from the gui. Still not letting me add the devices to the peer group.
- Christopher_NoyOK, for whatever reason, I was only able to get the device added via the CLI (tmsh) using this command found in SOL13639: modify /cm trust-domain /Common/Root ca-devices add { } name username password Not sure why it wasn't working via the GUI. I think I'll submit a ticket with F5 on Monday about this. Thanks for the suggestions.
