Forum Discussion

A1_248551's avatar
A1_248551
Icon for Nimbostratus rankNimbostratus
Feb 25, 2016

can not save configuration on VM F5 v 11

 

Hi Dev Central

 

I am still getting error not able to save the configuraion Refer to screenshot..below

 

application delivery
LTM

1 Reply

  • Lucas_Matorin_2's avatar
    Lucas_Matorin_2
    Icon for Nimbostratus rankNimbostratus
    Feb 26, 2016

    Hello A1,

    This initial configuration of the management interface does not need to be saved, since you accepted the settings are saved automatically.

    You can check this configuration looking on the interface eth0 on Linux.

    [admin@bigipalpha:Standby:In Sync] ~  ifconfig eth0

    Additionally i see that the MCP process is not running, use the command below to check the process.

    [admin@bigipalpha:Standby:In Sync] ~  bigstart status mcpd

    If the process is not running you can activate it using the following command.

    [admin@bigipalpha:Standby:In Sync] ~  bigstart start mcpd

    Hope it was useful.

    Best regards