Forum Discussion
CirrusCan not create vlan in F5
Please see below picture. The vlan cannot be created in F5. What is wrong? Anyone can give me suggestion? Thank you
11 Replies
Yann_DesmarestHi,
Which plateform do you run ? vCMP guest ? Virtual Edition ?
Do you get this warning during the wizard ?
eesun_276598Thank you so much for your reply. I am new to F5, My F5 is not virtual edition. It is real device. The F5 is old one and i am not running wizard. I am just trying to add a new vlan, and then I got that error message. Please let me know how to answer your other question. Thank you again
Yann_Desmarest_Nacreous
Hi,
Which plateform do you run ? vCMP guest ? Virtual Edition ?
Do you get this warning during the wizard ?
- eesun_276598Thank you so much for your reply. I am new to F5, My F5 is not virtual edition. It is real device. The F5 is old one and i am not running wizard. I am just trying to add a new vlan, and then I got that error message. Please let me know how to answer your other question. Thank you again
IainThomson85_1Cumulonimbus
Can you share the outputs of your interfaces ?
( list net interface / show net interface )
Whats going to be the purpose of this VLAN ?
- eesun_276598I got below info after I used that command. Do you think if my F5 is not in normal mode? Thank you [admin@LTM-6:Standby:Awaiting Initial Sync] ~ list net interface -bash: list: command not found [admin@LTM-6:Standby:Awaiting Initial Sync] ~ show net interface -bash: show: command not found
- eesun_276598
I got the below output after using that commands. I do not know whether it is not in the normal mode? The vlan is for routing purpose. Thank you
[admin@LAB-LTM-6:Standby:Awaiting Initial Sync] ~ list net interface
-bash: list: command not found
[admin@LAB-LTM-6:Standby:Awaiting Initial Sync] ~ show net interface
-bash: show: command not found
- IainThomson85_1You'd need to run the commands in TMSH. Enter tmsh at bash prompt.
- eesun_276598
Sorry for the delay due to other project
Now I still cannot create vlan as before. the below is output of command "show net interface"
Thank you
- boneyard
MVP
perhaps im missing something but nowhere i see the command you try and fails, please (re)post that, you also just execute one of the commands IainThomson85 is asking about.
