Can a Health Check be sourced from a SNAT address rather than the F5 self-ip?

Hi everyone,

I actually have a similar need to change the monitoring source-ip, and have indeed used the proposed method of using a SNAT pool + VS to capture the traffic that passes through

and all. The result seemed to be promising and while using the "test" button under the monitor the traffic did undergo the SNAT i intended it to.

The problem appeared only when i decided to use this monitor and associate it to the desired pool, in that case no SNAT is occuring.

Have you come to a solution since this was posted? any advice would be happily accepted.

cheers,