Forum Discussion

Eclipse_246639's avatar
Eclipse_246639
Icon for Nimbostratus rankNimbostratus
Feb 18, 2016

BigIP 11.3 LTM Pair not Clustering into HA

Hi all,   Relatively new to the BigIP arena, but I've enjoyed labbing the ADC's up in VM Workstation....until I got to HA, which has me a little stumped.   My issue arises when I run though the...
application delivery
BIG-IP
devops
LTM
  • Steve_245_23966's avatar
    Steve_245_23966
    Feb 19, 2016

    I've used the Lab licensed VEs quite a bit and they will support clustering. I think the cost is $100-$125 including support so it's a good deal. Also if your non-prod environment is relatively light you can use them for that.

     

Eclipse_246639's avatar
Eclipse_246639
Icon for Nimbostratus rankNimbostratus
Feb 18, 2016
In addition, within Device Management > Device Trust the status seems to be sat at Changes Pending, but I've tried several times to sync the config from the appliance with Nodes, Pools & Members to the pretty much bare ADC without success. Within Device Management > Overview I see my group made up of 2 members - however Changes Pending is listed under the Sync Status. A sync does not resolve this. Then under Devices I see my two devices, one stating Changes Pending and the other with a Sync Status of Disconnected. This is a little confusing as the appliance was able to pull back information about the peer, but for a reason that evades me, can't cluster.