Mo_Moghaddas
Feb 24, 2016Nimbostratus
BIG-IP Sync-Failover - Sync Failed
Hi,
In a project we're running a device-group in Sync-Failover* mode with Manual Sync type.
After a change on the Active unit trying to sync from the Active unit to the device-group, Sync Failed with the information below:
Sync Summary
Status Sync Failed
Summary A validation error occurred while syncing to a remote device
Details
Sync error on 2nd-unit: Load failed from 1st-unit 01070110:3: Node address 'node' is referenced by a member of pool 'pool'.
Recommended action: Review the error message and determine corrective action on the device
We're totally sure that nothing had been changed manually on the 2nd node, and both nodes were in sync before the change on 1st node.
The Last Sync Type field for both nodes shows Manual Full Node.
I couldn't find anything on this case; is it safe to just manipulate the configuration on the 2nd node and then sync from 2nd node to the device-group?
Many thanks in advance!