Forum Discussion

George_33482's avatar
George_33482
Icon for Nimbostratus rankNimbostratus
Dec 28, 2012

Active\active scenario

Hi,

 

I am trying to configure Viprion v11.2 in active/active mode. I have four vlans (Outside, two internal and one HA).

 

I create a self ip address with vlan internal1 with traffic-group-local-only and floating ip address with vlan internal1 with traffic-group(floating).

 

I then I created another traffic group (traffic-group2)

 

But i am facing a problem to create a self ip address to vlan internal2 with traffic-group-2 (there is no option with traffic-group2-local-only) there an option with traffic-group2 (floating) and off course I cannot create a floating ip address (with traffic-group2) without creating a self ip address first.

 

So how to create a traffic-group2-local-only the same as the default traffic-group-local-only?

 

 

Thank you for your support.

 

George

 

config
design

1 Reply

  • Hamish's avatar
    Hamish
    Icon for Cirrocumulus rankCirrocumulus
    Dec 28, 2012
    Mm... The local-only 'traffic groups' aren't really traffic groups. In that you don't see them on all the units. The -local-only traffic group is only available on the unit it's actually local to. And tyhere's only 1 per unit. You don't get a local-only for every floating traffic-group

     

     

    H