Forum Discussion
munish_64882
Nimbostratus
Nimbostratusaccess lost when click force standby
Hi All,
I am new to F5 technology.. so I am not aware if its a common behaviour of F5.
1. I have configured my Load Balancers to work in Active/standby state. but both the devices are always in active state.
Now, When I click force standby on secondary unit of LB, I lose access to device for few seconds. but when it comes up, Its again active.
Please tell me how should I cpme out of this situation.
19 Replies
munish_64882you mean, assigning dummy IP addresses to mgmt interface..? but these would not be physically connected anyway...- nitass
Employee
you mean, assigning dummy IP addresses to mgmt interface..? but these would not be physically connected anyway...yes please. - munish_64882It wont be possible...
Even if I assign the IP addresses to mgmt IP addresses, I will not be able to get them physically connected. - nitassif i do not misremember, i think it is okay even it is not physically connected.
- munish_64882I have lost the access to both the devices after I added the IP address to Load Balancers.
- nitassI have lost the access to both the devices after I added the IP address to Load Balancers.what ip did you use? it was not in any existing subnet, was it?
- munish_64882no it was not from any existing range
- nitassso, have you got access back? are they still active/active??
- munish_64882not yet.. I do not have the console to these devices...
