F5 Viprion power supply log
Hi Guys, Currently, we are planning to install F5 VIPRION 4480N along with one Blade 4300 type. Because of limited number of source power, we are planning to use 2 power supplies per-chassis. Power supply 1 and 4. Today, we powered-up this VIPRION on our lab. And found out that the power supply alarm and led keep blinking though we had cleared it several time before. The system displayed below log continously: Jun 9 03:40:02 slot1/localhost emerg system_check[11423]: 010d0006:0: Chassis power supply 2 has experienced an issue. Status is as follows: STATUS=bad. Jun 9 03:40:02 slot1/localhost emerg system_check[11423]: 010d0006:0: Chassis power supply 3 has experienced an issue. Status is as follows: STATUS=bad my question: 1. Is it okay to use only 2 power supplies only out of total 4? 2. Is there any way to disable this alarm? Thank you for any input
Amber Alarm LED but no alarm displayed in the LCD Panel
hi everyone. we have bigip2000 version 11.6.0. the led of the alarm is solid yellow. however, it does not display any alert in the LCD, dashboard or even the logs. what is the difference if the LED of the alarm is solid yellow and solid green? can anyone give me an article about these indicators, applicable to bigip2000 and version 11.6.0. Thank you guys.
"Emergency" alarm on VIPRION 2400 blade - cause and how to clear?
On the face of it a bit of a basic question this, but I can't find an answer in the F5 documentation. We have a red flashing "ALM" alarm on a B2100 blade in a VIPRION 2400. Can anyone guide me as to 1) how to find the cause of the alarm (I've looked in /var/log/messages - nothing relevant there) 2) how to clear the alarm (we have no LCD module) I understand it's possible the alarm is from a while ago and the cause is gone (the platform guide says "The Alarm LED might continue to display until alerts are cleared", but I still need to find the cause. Thanks in advance, Stuart
