Forum Discussion
JotaCePena_1783
Nimbostratus
NimbostratusVS with automap does not work but with snat_pool work fine
We have a VS with automap configuration, this VS worked fine until yesterday, after that, the VS does not work fine anymore. The only change in configuration was use a snat_pool instead automap. ...
I am assuming that the IP range of the SNAT pool is not within the same subnet range as the exit VLAN (ie when you use Automap it will select the self IP address of the exiting VLAN)
If this is the case it sounds like there is no route back to the SNAT pool. I would verify the network configuration to ensure there is a route back to the SNAT pool via the exit VLAN.
IainThomson85_1
Cumulonimbus
CumulonimbusI would look exactly where Rhys and Odaah have suggested.
If there is a fundamental routing issue (I.e. not on the same VLAN)... Alternatively if you've got an inline firewall/server firewall blocking the new IP address you've chosen.
