Forum Discussion
Luca_55898
Nimbostratus
NimbostratusVLAN Failsafe
I have two BIG-IP 1600 in a HA config.
I need a failover to occur if the active unit looses its network connection to the internal and/or external network.
So i have configured VLAN Fai...
nitass
Employee
EmployeeShould I configure the VLAN Failsafe failover only in the active unit? Or the best practice is to configure it on both active and standby units? I'm running version 10.2.you can configure vlan failsafe on both units but just want to make sure they are not triggered at the same time.
anyway, if you want to just failover when interface on bigip is down, i think ha-group might be better solution.
Configuring HA groups
http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/tmos_management_guide_10_1/tmos_high_avail.html1026652
