virtual server fault tolerance (active-passive)

Question

Hi,I have two servers that are working in active-passive mode.Each server has a unique DNS entry.The active server has been configured in F5 and is working properly.The goal is to be able to use a single URL and to have F5 forward the traffic to the active server based on the state of the servers.appliance version is&nbsp;12.1.2Thanks,Felix&nbsp;&nbsp;

sebastiansierra · Answer

Hi,You can use&nbsp;Priority Group Activation to assign a higher value to the principal server, and, if it fails, send the request to the second server with a lower&nbsp;Priority Group Activation.Follow this link to configure it:https://support.f5.com/csp/article/K13525153#:~:text=To%20enable%20priority%20group%20activation,in%20a%20lower%20priority%20group.

fz · Answer

Thank you for your response.This does not achieve the goal of a single URL for both servers...As my chname points to one virtual server..

fz · Answer

Hi,unfortunetly not yet..

Forum Discussion

virtual server fault tolerance (active-passive)

Recent Discussions

Check how long it takes for a request to switch from a pool member to another if one is not available

anti-bot ip exclude

F5 VIP listens on udp port 514 and forwards to all servers in pool

How to accept Application requests at WAF F5

Yubikey APM and AzureAD question

Related Content

Especial Load Balancing Active-Passive Scenario (II)

Integrating SSL Orchestrator with Cisco WSA Virtual Edition

Data Center Feng Shui: Fault Tolerance and Fault Isolation

F5 virtual edition license issue.

Migration F5-DNS-VM from a Virtual Machine to other Virtual Machine