Forum Discussion
smp_86112
Cirrostratus
Cirrostratusv9 matchclass and v10 class match iRule commands
I've got a v9 irule that takes action based on whether or not the client IP address is in a data class. The v9 iRule looks like this:
if { [matchclass [IP::remote_addr] equals $::allow...
hoolioCirrostratus
CirrostratusHi SMP,
The class contents aren't normally stored in the same order they are listed in the bigip.conf. That was supposed to be the literal log output, but I think I copied a line incorrectly. The first line should have $:: in the datagroup name. The first two log lines of the iRule were intended to show that you could access the datagroup by name with $:: as a prefix when not using TCL list commands. Doing so would break CMP compatibility for the VIP though, so it's better to not use $:: at all in 9.4.4 or higher.
Aaron
