Forum Discussion
nycdude
Nimbostratus
NimbostratusUnable to add disk to array
Hello everyone, We have an F5 7000S that we have purchased new in 2013 and kept it running pretty much 24/7 all this time. After a datacenter outage one of the drives in the device died. We have...
CA_Valli
MVP
MVPI'm guessing the replacement disk you installed was not F5-supplied, correct?
First thing I'd check is if it's being seen by the unit, do the LEDs blink? What's the output of tmsh show sys raid disk ?
Also, what procedure did you use to unmount the disk? Did you remove it from the array before switching it as detailed in https://techdocs.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/platform-b7000/4.html#c_reuse_fru_hd_about ?
- nycdude
That is correct.
The replacement disk is a Samsung EVO 870 SSD.
I tried replacing it with the same identical vendor (not F5 sourced though) WD-Velociraptor 1TB, but the results are the same.
here is the output of the command. The disk is recognized, just wont add to raid.
---------------------------------------------------------------------
Sys::Raid::Disk
Name Serial Number Array Array Status Model
Member
---------------------------------------------------------------------
HD1 WD-WXR1E63HMUYD yes ok ATA WDC WD1000CHTZ-0
HD2 S6PNNJ0W412826X no undefined ATA Samsung SSD 870