Forum Discussion

Nimbostratus

7 years ago

Solved

traffic from APM to Domain Controller

Hello, We have configured the APM for exchange 2016 to use NTLM in test environment and it is working fine . the communication from LTM is open to DC over the management interface. Now moving on...

application delivery

BIG-IP Access Policy Manager (APM)

devops

LTM

kolom_265617
7 years ago
Hello Maryam,

You can use either Management interface or TMM interface to reach your Domain controller. If a destination address does not match that of the management interface network, and no static route is specified besides a default management gateway, the system uses the default gateway that the TMM specifies.

So just make sure that the DC is reachable to F5 , and the required ports and services is enabled.

Note : if SMBv1 is disabled on the DC . this will cause the BIG-IP APM system not to be able to successfully authenticate clients using NTLM. https://support.f5.com/csp/article/K55889450

kolom_265617

Cirrostratus

7 years ago

Hello Maryam,

You can use either Management interface or TMM interface to reach your Domain controller. If a destination address does not match that of the management interface network, and no static route is specified besides a default management gateway, the system uses the default gateway that the TMM specifies.

So just make sure that the DC is reachable to F5 , and the required ports and services is enabled.

Note : if SMBv1 is disabled on the DC . this will cause the BIG-IP APM system not to be able to successfully authenticate clients using NTLM. https://support.f5.com/csp/article/K55889450