This should not be so difficult.

Also, what am I doing to reset Automatic Policy Builder or why is F5 resetting? I have earlier today as well as in the past manually went to parameters (e.g., lastname, firstname, middlename, homestreet, et cetera) to click the ALLOW EMPTY VALUE because I have received errors when I was processing in the web app to test and utilize F5. For a while I might stop getting the errors for those parameters when I do not enter anything while I am processing to test F5 within the web app, but then YET AGAIN I eventually receive an Illegal Empty Parameter Value error.

 

 

If Automatic Policy Builder is running and I get an error for one of its parameters, 1) can I click ACCEPT on the error to allow in the future the value entered, and if so, do I then need to click APPLY POLICY for the security policy as I have been doing? 2) can I also go to the parameter directly to click to allow an empty value and then click APPLY POLICY as I have been doing? Are these two valid ways to respond to the error and are they equivalent of each other? Why then do I again receive an error about Illegal Empty Value when I have clicked ACCEPT on these errors for the parameters and then applied the policy numerous times AND when I have gone to the parameters manually to click to allow empty values for these parameters?

 

 

Thanks.