Forum Discussion

Bensonlin_13820's avatar
Bensonlin_13820
Icon for Nimbostratus rankNimbostratus
Feb 09, 2014

The Failover status of iHealth

Hello everyone….

 

I have some problem….Hoping guys could help me….

 

I use setup utility in LTM V11.4.1 to configure Failover and it works,

 

but when I upload the qkView file to iHealth,

 

the status in iHealth show that Failover does’t configure….

 

Could someone explain it？ Many thanks！！

 

deployment
ihealth

4 Replies

  • Vitaliy_Savrans's avatar
    Vitaliy_Savrans
    Icon for Nacreous rankNacreous
    Feb 10, 2014

    If you will give more information about you configuration of the failover, you will get more sugestions.

     

  • Bensonlin_13820's avatar
    Bensonlin_13820
    Icon for Nimbostratus rankNimbostratus
    Feb 12, 2014
    Thanks for your advice！ I have 2 BigIP 7000S platforms and the module contain LTM V11.4.1 Following the initial set up flow（Run the Setup Utility） to create Sync-Fail status （I have created Device-Group and choose the Network failover function） Power off or changing the platform status Active-Standby to Standby-Active and working… But when I upload the qkview to iHealth… The list in iHealth Status->Failover->Network->Peer IP address show that I did’t configure Peer IP…. Here is the Link https://www.dropbox.com/s/tklth7xjmycwrn5/sampo.png But I truly trust each other and create Device-Group let failover function up… Why the peer IP show nothing? （I use LTM v10.1 VE upload again and the Peer IP is correct）
  • Bensonlin_13820's avatar
    Bensonlin_13820
    Icon for Nimbostratus rankNimbostratus
    Feb 16, 2014

    Hi All： I know this is not a question~ Because the Failover just working... But this question challenged from my customer , So ~

     

    This is the answer maybe....

     

    In V10： If someone create Failover status , you must configure the other device first. The status in iHealth-Failover-Network-Peer IP is correct so.

     

    In V11： The new concept about Failover is Device Group , you can create more than 1 device. This is the reason why status in iHealth-Failover-Network-Peer IP show nothing.