SNMP Configuration

Hello, I am configuring BIG IP as per below steps but SNMP server is not getting any information about my BIG IP.

To allow monitoring of the SNMP agent 1.On the Main tab of the navigation pane, expand Network, and click Self IPs. The Self IPs screen opens.

2.If you have not configured the self IP address that you will use for monitoring the SNMP agent, click the Create button. Otherwise, in the IP Address column, click a self IP address.

3.From the Port Lockdown menu, select Allow Custom. This displays the Custom List setting.

4.Click UDP.

5.Click Port, and in the box, type 161 (the well-known port number for SNMP).

6.Click Add. The port number appears in the UDP box.

7.Click Finished or Update.

To grant community access to SNMP data (v1 or v2c only) 1.On the Main tab of the navigation pane, expand System, and click SNMP. This opens the SNMP Agent Configuration screen.

2.From the Agent menu, choose Access (v1, v2c). This displays the SNMP Access screen.

3.In the upper-right corner of the screen, click Create. This displays the New Access Record screen.

4.Select the type of address to which the access record applies, either IPv4 or IPv6.

5.In the Community box, type the name of the SNMP community for which you are assigning an access level (in step 8).

6.In the Source box, type the source IP address.

7.In the OID box, type the OID for the top-most node of the SNMP tree to which the access applies.

8.For the Access setting, select an access level, either Read Only or Read/Write. (This access level applies to the community name you specified in step 5.)

9.Click Finished.