Forum Discussion
Jose_Nelson_206
Nimbostratus
NimbostratusSNAT using specific IP based on the client IP range
I'm needing to use an iRule to determine if a client connection comes from IP 10.1.0.0/25 then SNAT using a specific IP instead of the default AutoMap SNAT IP. I found the iRule below and have tried...
Amine_Kadimi
MVP
MVPIf it is OK for you, you can use two VS with same destination IP, same port, but different source addresses, one with 10.1.0.0/25 and the other with 0.0.0.0/0. The most specific will match first if client comes from 10.1.0.0/25, the less specific will match other connections. You then can play with the SNAT setting without an irule.
